The base of cantilever shelf can be made of H-shaped steel or special profiles. The selection of H-shaped steel is based on the load-bearing requirements and the corresponding national standard steel. Open the bolt connection eye with the column on the upper side of the H-shaped steel to facilitate the connection with the column. Weld the bottom plate at the bottom, and open the expansion bolt eye on the bottom plate to facilitate the connection of the shelf to the ground with expansion bolts. To fix the shelf.
The cantilever shelf uses a special profile as the base, and welds two pieces of C-shaped steel back to back with a connecting steel plate. The width of the connecting steel plate is the width of the column. After the two pieces of C-shaped steel are welded, open the connection bolt eye at the connection column position to facilitate the connection with the column. Weld the connecting bottom plate to facilitate the connection of the expansion bolt to the ground.
The column of the cantilever shelf is welded together with two pieces of C-shaped steel. The C-shaped steel is made of Q235 high-quality strip steel as the raw material. After being rolled into C-shaped steel by the rolling mill line, the cantilever connection control is punched out on the automatic punching machine, and the hole spacing is 140mm. If the column is connected with H-shaped steel, a connecting steel plate will be welded under the column. If the column is connected with special profiles, bolt connection holes will be opened at the connection part under the column.
