1. Load limit signs should be set on steel platforms.
2. The placement points and upper tie points of the steel platform must be located on the building and must not be set on construction facilities such as scaffolding, and the support system must not be connected to the scaffolding.
3. The concrete beams and slabs at the placement points of the steel platform should be embedded and connected to the bolts of the platform.
4. The horizontal angle between the wire rope and the platform should be 45 to 60 degrees.
5. The tensile strength of the beams and columns at the upper tie points of the steel platform should be verified to ensure the safety of the building and the platform.
6. When installing the steel platform, a clamp ring should be used, and the hook should not be directly hooked on the platform ring.
7. When installing the steel platform, the wire rope should be hung with a special hook. When other methods are adopted, there should be no less than 3 buckles. The sharp corners of the building should be padded with soft pads, and the outer opening of the steel platform should be slightly higher than the inner side.
8. Fixed guardrails must be set on both sides of the steel platform and a dense safety net should be hung.
